10-13-2018, 04:29 PM
The TUT series recommends a lot more fusing than most builders use for MI tube amps but it make sense to me to provide the maximum protection possible to the transformers and thus also protecting the owner from expensive replacements. Up until now I've been using two panel mounted fuse holders (one for the mains and on on the HT).
I've been trying to work out the best method or part to use to mount fuse clips/holder to the eyelet boards so I can add more fusing. What method do you guys use? Any recommended fuse holder/clips/fuse blocks that are easy to mount on a eyelet board? Is it preferable to still have some of the fuses be panel mounted or better to have them all be internal. Thanks!
I've been trying to work out the best method or part to use to mount fuse clips/holder to the eyelet boards so I can add more fusing. What method do you guys use? Any recommended fuse holder/clips/fuse blocks that are easy to mount on a eyelet board? Is it preferable to still have some of the fuses be panel mounted or better to have them all be internal. Thanks!