London Power ad

[-]
Search the Forum








(Advanced Search)

London Power Best All-Tube Effects Loop (BFX)
#1
Have any Forum users tried this? Share your experiences and questions.

London Power's "Best All-Tube Effects Loop" (BFX): the tube solution for active effects loop requirements
  • tube-buffered input and 'send'
  • tube mixing stage using virtual-earth mixer
  • level controls and jacks for 'send' & 'return'
  • 'series/parallel' switch
  • local decoupling included
  • operates from 160-450Vdc 2mA
  • heaters can be run at 6V 300mA or 12V 150mA
  • PCB & instructions included

Kit form of the "Best All-Tube Effects Loop" from the book The Ultimate Tone. The 'send' is buffered, eliminating problems with long cables to your effects. The return input has enough gain to support pedals used in the loop even if the loop is inserted in a high-level signal point in your system. Quiet! So quiet the loop can be used at the front end of your guitar rig. Use any 12A_7. The whole board + tube (tube not included) can be contained in the chassis.

More info at London Power: London Power's Best All-Tube Effects Loop

[Image: bfx_parts_500.jpg]
Reply
#2
Hello. I have this kit in a 2U unit. Im planning on putting it in a 1u rack, what is the best way of mounting it 90 degrees? Thanks
Reply
#3
https://uk.farnell.com/ettinger/14-86-35...dp/1466885

I'm presuming something like this will be used?
Thanks
Adam
Reply
#4
Hi Adam

Your linked bracket is too large and will foul on traces on the board.

The space around the holes will accommodate keystone 612 and 621 brackets - the 612 has untapped holes which would allow you to use metric bolts. The 621 has 4-40 tapped holes.

The keystone brackets might not allow mounting in 1U unless the chassis itself is a but tight to the 1U dimension as the brackets add some height to the 1.5" (38.1mm) of the PCB.

An alternative mounting is to make your own brackets, since they are pretty small and easy to fabricate. Drill the holes first then use tin snips to cut the metal and bend with pliers. This allows a much tighter fit of the bottom edge of the PCB to the chassis floor.

A more elaborate form of rolling your own would be to copy the hole centres and tube socket centre onto a flat piece of aluminium, drill the holes and cut out a hole to clear the tube, then bend the piece so there is a large foot that can be bolted to the chassis. use standoffs to secure the PCB to the aluminium shield.
Reply
#5
Hi. Thank you very much, I've found a supplier for those parts in the UK. Hopefully do the swap with out too much trouble! Thanks again, Adam.
Reply


Forum Jump:

[-]
Come in where it's warm!
A warm welcome to tube amp modding fans and those interested in hi-fi audio! Readers of Kevin O'Connor's The Ultimate Tone (TUT) book series form a part of our population. Kevin O'Connor is the creator of the popular Power Scaling methodology for amplifiers.
Please remember these three principles: respect, sharing, community.
Not familiar with The Ultimate Tone book series? See discussion topics, or click here to visit London Power/Power Press Publishing.

[-]
Tube Amp Forum Hosted by London Power
London Power logo