London Power ad

[-]
Search the Forum








(Advanced Search)

Question about the Sigma Project
#1
I'm thinking about building the Sigma as floor based unit with the switching on the unit itself.   Since the unit is going to be remote form the amp with 20ft cable is there any concern about signal loss?  Would it be wise to have cathode follower or transformer to have a lo-z out or is that non-issue?

Thanks!
Reply
#2
Hi makinrose

Sigma nominally has a low-z output due to the feedback around the mixing stage. You should build it as is and try it with a long cable and a short cable to hear if there's a difference. If there, the best solution is to add a BJT buffer directly to the mix stage plate. Surprisingly, this provides a better frequency response than a mosfet would.

Have fun
Reply
#3
(01-05-2019, 12:29 AM)K O\Connor Wrote: Hi makinrose

Sigma nominally has a low-z output due to the feedback around the mixing stage. You should build it as is and try it with a long cable and a short cable to hear if there's a difference. If there, the best solution is to add a BJT buffer directly to the mix stage plate. Surprisingly, this provides a better frequency response than a mosfet would.

Have fun

Excellent! Thanks for the help.  If necessary the BJT will be easy to add.
Reply


Forum Jump:

[-]
Come in where it's warm!
A warm welcome to tube amp modding fans and those interested in hi-fi audio! Readers of Kevin O'Connor's The Ultimate Tone (TUT) book series form a part of our population. Kevin O'Connor is the creator of the popular Power Scaling methodology for amplifiers.
Please remember these three principles: respect, sharing, community.
Not familiar with The Ultimate Tone book series? See discussion topics, or click here to visit London Power/Power Press Publishing.

[-]
Tube Amp Forum Hosted by London Power
London Power logo