![[-]](https://theultimatetone.com/images/collapse.png "[-]")
11-22-2018, 03:07 PM
(This post was last modified: 11-22-2018, 03:17 PM by Vostre Roy.
Edit Reason: Flipped the back plate picture
)
Allright, here's version 2!
As M. O'Connor proposed, I've swapped the OT and PT, brought the clean channel along with the OD channel and put the PA section under the Lead channel. The two fuses that were on the back of the amp was a mistake, I knew that there was two fuses but forgot they were directly on the board. I've also swapped the Send and Return of the FX loop. Pilot light is out, I wanted to keep it but didn't found a place that would look good with the new layout, anyway as Kevin pointed out, the channel's led will show if the amp is on or off anyway.
Front view
Back view
Top view
Once again, thanks to M. O'Connor for the help!
As M. O'Connor proposed, I've swapped the OT and PT, brought the clean channel along with the OD channel and put the PA section under the Lead channel. The two fuses that were on the back of the amp was a mistake, I knew that there was two fuses but forgot they were directly on the board. I've also swapped the Send and Return of the FX loop. Pilot light is out, I wanted to keep it but didn't found a place that would look good with the new layout, anyway as Kevin pointed out, the channel's led will show if the amp is on or off anyway.
Front view
Back view
Top view
Once again, thanks to M. O'Connor for the help!
