![[-]](https://theultimatetone.com/images/collapse.png "[-]")
11-22-2018, 04:30 PM
Hi Vostre
Looks good!
The layout now has a smooth signal flow and power flow. There could be a little bit of a cluster between the preamp cards and the controls, but there's always something of that nature in every layout that is more complicated than a single-channel amp.
Remember that the OT and PT wires need protection from the edges of the holes through the chassis - deburr the holes as always but also use rubber grommets or nylon "caterpillar". Adding either requires a larger hole than just that needed for the wire. Unfortunately, the "approved" wire for transformer terminations has quite thick insulation.
Have fun
Looks good!
The layout now has a smooth signal flow and power flow. There could be a little bit of a cluster between the preamp cards and the controls, but there's always something of that nature in every layout that is more complicated than a single-channel amp.
Remember that the OT and PT wires need protection from the edges of the holes through the chassis - deburr the holes as always but also use rubber grommets or nylon "caterpillar". Adding either requires a larger hole than just that needed for the wire. Unfortunately, the "approved" wire for transformer terminations has quite thick insulation.
Have fun
