London Power ad
Tube Amp Forum: The Ultimate Tone › Tube Amp Community (Hi-fi too!) › Power Scaling
Question about filament transformer for bias supply in a Power Scaled Amp

[-]
Search the Forum








(Advanced Search)

Linear Mode
Question about filament transformer for bias supply in a Power Scaled Amp
makinrose Offline

Posts: 197
Threads: 31
Joined: Oct 2018
Location: United States
Country: United States
#1
02-06-2020, 02:05 PM (This post was last modified: 02-06-2020, 04:22 PM by makinrose.)
This might be dumb question....I'm typically using a DC elevated heaters like what is shown in TUT 3 and TUT5. If I need to run a filament transformer for the bias supply off of the heater supply do need to remove the DC elevation or use caps to block the DC?  Huh
Find
Reply


Messages In This Thread
Question about filament transformer for bias supply in a Power Scaled Amp - by makinrose - 02-06-2020, 02:05 PM

Forum Jump:

[-]
Come in where it's warm!
A warm welcome to tube amp modding fans and those interested in hi-fi audio! Readers of Kevin O'Connor's The Ultimate Tone (TUT) book series form a part of our population. Kevin O'Connor is the creator of the popular Power Scaling methodology for amplifiers.
Please remember these three principles: respect, sharing, community.
Not familiar with The Ultimate Tone book series? See discussion topics, or click here to visit London Power/Power Press Publishing.

[-]
Tube Amp Forum Hosted by London Power
London Power logo