![[-]](https://theultimatetone.com/images/collapse.png "[-]")
01-07-2022, 03:32 PM
Hi Guys
As from the first post, whether you add this second GLI depends on what XLR jack you use..
One with pin-1 tied to the mounting screw does not need the GLO. Just float the TX output to the XLr pins 2+3, with or without the pot in between
If the XLR has a floating pin-1, then tie it to the chassis directly near the XLR.
The GLI is only added if you want a soft ground at the amp end and this is only for the XLR.
The amp itself has a chassis tie point via its own GLI as usual.
The Hammond TX should only have four connections used, those for the ends of the windings. The CTs are left open.
As from the first post, whether you add this second GLI depends on what XLR jack you use..
One with pin-1 tied to the mounting screw does not need the GLO. Just float the TX output to the XLr pins 2+3, with or without the pot in between
If the XLR has a floating pin-1, then tie it to the chassis directly near the XLR.
The GLI is only added if you want a soft ground at the amp end and this is only for the XLR.
The amp itself has a chassis tie point via its own GLI as usual.
The Hammond TX should only have four connections used, those for the ends of the windings. The CTs are left open.
