![[-]](https://theultimatetone.com/images/collapse.png "[-]")
10-06-2022, 04:20 AM
Hello Builders!
What is your experience with a step bit?
I bought one and it is sharp.
Still, when working on a thin sheet of metal I had to use a lot of force and ther was a terrible noise, but not much was cut.
And yes, the drill was even spinning the right way.
I saw Brad Lindsey use one on a thick chassis and that seemed to work very fine!
So, I am very cusious to what your adventures are!
Strelok
What is your experience with a step bit?
I bought one and it is sharp.
Still, when working on a thin sheet of metal I had to use a lot of force and ther was a terrible noise, but not much was cut.
And yes, the drill was even spinning the right way.
I saw Brad Lindsey use one on a thick chassis and that seemed to work very fine!
So, I am very cusious to what your adventures are!
Strelok
